HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L
848-D3Z-93A0 (005)
U
S
OWNER'S/OPERATOR'S
MANUAL
HEDGE TRIMMER
HTZ2460
HTZ2460L
CHTZ2460
CHTZ2460L
WARNING
The engine exhaust from this
product contains chemicals
known to the State of California to
cause cancer, birth defects or
other reproductive harm.
WARNING
Before using our products,
please read this manual carefully
to understand the proper use of
your unit.
This spark ignition system complies with
the Canadian standard ICES-002.
US-1
HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L
1. Parts location
U
S
1. Front handle
2. Rear handle
3. Ignition switch
4. Throttle lever
5. Safety lock
6. Blade
9. Starter knob
10. Primer pump
11. Fuel tank
12. Fuel tank cap
13. Choke lever
14. Air cleaner cover
15. Spark plug cap
7. Gear case
8. Spark arrester
2. Specifications
Model
Type
HTZ2460
HTZ2460L
CHTZ2460
Reciprocating
double-sided dual blades
CHTZ2460L
Reciprocating
single-sided dual blades
Dry weight
Blade size
Blade pitch
Transmission
Reduction ratio
5.8(kg)/12.6(lbs)
750(mm)/30(in)
35(mm)/1.38(in)
6.4(kg)/14.1(lbs)
1080(mm)/42.5(in)
34(mm)/1.34(in)
5.8(kg)/12.8(lbs)
600(mm)/24(in)
6.0(kg)/13.2(lbs)
750(mm)/30(in)
35(mm)/1.38(in)
Centrifugal clutch, Cam-crank
4.5
Air-cooled 2-stroke gasoline
GZ23N
Engine
Type
Mode
3
Displacement
Max. output
Idle speed
Fuel
23.6(cm )/1.44(cu-in)
-1
1.15Hp(0.85kW)/8000min (rpm)
-1
3000 200/min (rpm)
:
mixture(Gasoline 50 Oil 1)(when using RedMax genuine oil)
Carburetor
Spark plug
Walbro Diaphragm type
NGK CMR7H
Fuel tank capacity
Durability period
0.47(litter)/15.9(fl.oz)
300(hrs.)
Specifications are subject to change without notice.
US-3
HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L
3. Warning labels on the machine
(1) Read owner's manual before operating this machine.
(2) Wear head, eye and ear protection.
(3) Handling this machine improperly could result in
accidents causing serious injury or death. Read this
manual carefully and practice using the hedge-trimmer
until you are fully acquainted with all operations and have
learned to use it correctly.
(4) This is extremely sharp and can easily cause cuts.
IMPORTANT
If warning label peel off or become soiled and impossible to read,
you should contact the dealer from which you purchased the
product to order new labels and affix them in the required
location(s).
WARNING
Never modify your machine.
We won’t warrant the machine, if you use the remodeled
hedge-trimmer or you don’t observe the proper usage written
in the manual.
4. Symbols on the machine
For safe operation and maintenance, symbols
■ EMISSION CONTROL
are carved in relief on the machine. According
to these indications, please be careful not to
take a mistake.
An emission control label is located on the engine.
EMISSION CONTROL INFORMATION
THIS ENGINE MEETS U.S. EPA AND CALI-
1
FORNIA EXH / EVP REGS FOR 2010* S.O.R.E.
(a) The port to refuel the "MIX GASOLINE"
Position:
FUEL TANK CAP
2
ENGINE FAMILY : AHQZS.0244XY* DISPL.: 24cc
3
EMISSION CONTROL SYSTEM : EXH;EM/EVP;SP*
COMPLIANCE PERIOD : 300 HOURS
REFER TO OPERATOR'S MANUAL FOR MAINTE-
NANCE, SPECIFICATIONS AND ADJUSTMENTS.
MANUFACTURED:
(b) The direction to close the choke
Position:
USE JASO FD OR ISO L-EGD GRADE 50:1 OIL
AIR CLEANER COVER
*1: The year will be changed every year of manufacturing.
*2: The initial will be changed every year of manufacturing.
*3: SP : Sealed tank made of HDPE or PE.
(c) The direction to open the choke
Position:
AIR CLEANER COVER
US-4
HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L
5. For safe operation
other times when your field of vision
might be limited and it would be difficult
to gain a clear view of the working area.
c. During rain, during storms at times of
strong or gale-force winds, or at any
other times when weather conditions
might make it unsafe to use the
product.
1. THIS MACHINE CAN CAUSE
SERIOUS INJURIES. Read this manual
carefully until you completely
understand and follow all safety and
operating instructions. Also, know how
to stop the machine quickly in an
emergency.
2. Keep this manual handy so that you
may refer to it later whenever any
questions arise. Also note, if you have
any questions which cannot be
answered herein, contact the dealer
from whom you purchased the product.
3. Always be sure to include this manual
when selling, lending, or otherwise
transferring the ownership of this
product.
U
S
■ WORKING PLAN
1. You should never use the product when
under the influence of alcohol, when
suffering from exhaustion or lack of sleep,
when suffering from drowsiness as a result
of having taken cold medicine or at any
other time when a possibility exists that
your judgment might be impaired or that
you might not be able to operate the
product properly and in a safe manner.
2. When planning your work schedule, allow
plenty of time to rest. Limit the amount of
time over which the product is to be used
continuously to somewhere around 30 ~ 40
minutes per session, and take 10 ~ 20
minutes of rest between work sessions.
Also try to keep the total amount of work
performed in a single day under 2 hours or
less.
4. Never allow children or anyone unable
to fully understand the directions given
in the manual to use the machine.
■ WORKING CONDITION
1. When using the product, you should wear
proper clothing and protective equipment.
(1) Helmet
(2) Ear protectors
(3) Protection goggles or face protector
(4) Thick work gloves
(5) Non-slip-sole work boots
WARNING
1. If you don’t observe the working time,
or working manner (See “USING THE
PRODUCT”), Repetitive Stress Injury
(RSI) could occur.
If you feel discomfort, redness and
swelling of your fingers or any other
part of your body, see a doctor before
getting worse.
2. To avoid noise complaints, in general,
operate product between 8 a.m. and 5
p.m. on weekdays and 9 a.m. to 5 p.m.
on weekends.
2. And you should carry with you.
(1) Attached tools
(2) Properly reserved fuel
(3) Spare blade
(4) Things to notify your working area
(rope, warning signs)
(5) Whistle (for collaboration or emergency)
(6) Hatchet or saw (for removal of
obstacles)
(7) First-aid kit
NOTE
3. Do not wear loose clothing, jewelry, short
trousers, sandals, or go barefoot. Do not
wear anything which might be caught by a
moving part of the unit. Secure hair so it is
above shoulder length.
Check and follow the local regulations as to
sound level and hours of operations for the
product.
■ BEFORE STARTING THE ENGINE
1. The area within a perimeter of 15 m (50 ft)
of the person using the product should be
considered a hazardous area into which no
one should enter. If necessary, yellow
warning rope, warning signs should be
placed around the perimeter of the area.
When work is to be performed
■ WORKING CIRCUMSTANCE
1. Never start the engine inside a closed
room or building. Exhaust gases contain
dangerous carbon monoxide.
2. Never use the product,
a. when the ground is slippery or when
you can’t maintain a steady posture.
b. At night, at times of heavy fog, or at any
simultaneously by two or more persons,
US-5
|