15-1186.fm Page 1 Thursday, July 15, 1999 1:47 PM
Cat. No. 15-1186
To mount the TV FM Flush Mount Wall Plate:
3
1. If there is no wall box, cut a 1 /4 ¥ 4 inch hole in the
wall at the desired location.
2. Across the top of the hole, position a flat bracket
piece against the inner wall surface and an angled
bracket piece against the outer wall surface (with the
recessed part inside the hole).
(L) illus of hole on wall w/
dimension lines
(R) illus of wall cross-sect
w/brackets and screws;
size to fit text margins
3. Thread two of the supplied long bolts through the
two outer holes on the bracket pieces.
4. Repeat Steps 2 and 3 across the bottom of the hole
1
so the center hole in the bottom bracket is 3 /4
inches below the center hole in the top bracket (to
match the distance between the mounting holes on
the wall plate).
Custom Manufactured in Taiwan for RadioShack
A Division of Tandy Corporation
Fort Worth, Texas 76102
|